1. The three heat-tight methods are wheat heat, cylinder heat and material heat. Choose sunny and hot weather. After thawing the cement field around 9am, spread the wheat to the drying field first (thickness is about 1cm), and then cover the wheat material (quilt, blanket, and old Sack, etc.) to move out to dry, use dichlorvos or pest control phosphorus spray disinfection. The wheat must be turned over and turned at least once per hour with a mallet so that the temperature of the bark reaches 46-50°C and the moisture drops below 12.5%. The pile is gathered around 3 pm, and it is hot and stuffy for half an hour. Cylinder. Then use the sterilized material to cover, and then seal the cylinder mouth with a film, tightly with a rope, no leakage, so that the temperature of the cylinder in the cylinder reaches 40 °C above, keep 8 to 10 days, killing the dead eggs, Larvae, larvae and adults, so as to achieve insecticidal effect.
2. Hypoxic custodial method Wheat hypoxia storage mainly uses the characteristics of a long ripening period, high grain temperature in the inlet, and vigorous breathing, and it is a method of natural anaerobic storage in the condition that the wheat is sealed in the cylinder. The oxygen in the cylinder gradually decreases with the respiration of wheat and pests and microorganisms. The oxygen concentration can be reduced to 2% to 5% within 5 to 10 days, and the carbon dioxide concentration can be increased to 40% to 50%. For a certain period of time, pests can suffocate. However, it should be noted that the moisture of wheat should be controlled within the standard (less than 12.5%) and the average grain temperature should be above 30°C.
3. The method of chemical preservation can be used to store wheat in the cylinder under good sealing performance. It can be preserved with aluminum phosphide chemical reagents, or stored with low oxygen and low doses. It can also be stored with pests and phosphorus and wheat to prevent pests. And the breeding of mold, improve the stability of stored grain. For wheat that does not achieve control by natural oxygen deficiency, chemical preservation is the most suitable. The method of administration is to use gauze to wrap the tablets tightly in the grain heap. This method is suitable for long-term storage, aluminum phosphide tablets generally use 3 to 5 grams per ton, the cost of 1 yuan.
[Composition]
The main component of this preparation is human immunoglobulin, which is prepared by cold ethanol fractionation of human plasma from healthy donors. The manufacturing process contains a step to remove anticomplementary activity and a dual viral inactivation process. It contains a suitable amount of glucose or maltose as stabilizer (see table below), but does not contain any antiseptic or antibiotic. The distribution of IgG subclasses is close to the serum level of normal subjects and maintains the bioactivity of Fc fragment of IgG.
[Indications]
1. Primary
agammaglobulinemia, such as X-linked hypogammaglobulinemia,
common variant immunodeficiency diseases, immunoglobulin G subclass deficiency,
etc.
2. Secondary
immunoglobulin deficiency diseases, such as severe infection, septicemia of
newborn, etc
Intravenous Injection Of Human Immunoglobulin
Intravenous Injection Of Human Immunoglobulin,Intravenous Immunoglobulin,High-Quality Effective Intravenous Immunoglobulin,Human Immunoglobulin For Intravenous Injection
Sichuan Yuanda Shuyang Pharmaceutical Co., Ltd. , https://www.syimmunoglobulin.com