With the advancement of technology, the heat shrink packaging machine has also accelerated the pace of development, both in terms of technology and in terms of types and functions. The diversification of production has made the company consider more when purchasing the heat shrink packaging machine. The most important thing is whether the function is complete and the packaging range is wide. Heat shrink packaging machine manufacturers will develop and produce different heat shrink packaging machines according to the needs of enterprises, in order to better meet the production of enterprises.
Modern enterprise production, more is the choice of assembly line operations, packaging is not listed, the choice of packaging production line, and in order to better match the production line operations, heat shrink packaging machine manufacturers to consider its matching. However, when the heat shrink packaging machine is applied to the production line, we must ensure its stability and compatibility with other equipment. Based on many years of experience, Pikeron found that some common faults occurred when the heat shrink packaging machine was applied to the production line. Below, let's explain common faults and some solutions for the enterprise.
1. The heat shrinkable packaging machine is easy to shift during the packaging production and cannot feed normally. This will make the heat shrink packaging machine unable to heat shrink the package. Therefore, the film roll position and the tension balance bar can be adjusted. Both are invalid and can be solved by adjusting the angle of the upper triangular plate. The upper layer of film material is offset from the entrainment chain, and the upper triangular plate can be adjusted in a clockwise direction; the following layer of film material is offset from the entrainment chain, and the upper triangular plate can be adjusted counterclockwise. This will solve this problem.
Second, when the heat shrink packaging machine is in the production of packaging, the heating temperature of the packaging part is slow or can not reach the standard packaging temperature (above 160 degrees Celsius). This problem can cause the packaging to fail to achieve the intended packaging purpose. The heating process depends on the heater. The main power line of the heater should be checked first. The line of the heater is the main power line through a magnetic switch and then to the electric heating tube. Therefore, it is necessary to first check whether the contacts of the magnetic switch are normal. The above phenomenon occurs when the line does not pass one of the phases. If the magnetic switch is normal, you can check the meter again to see if the phase and the ohmic value of the machine are the same. If it is normal, it should be a short circuit. If the phases are all connected but the line or heating tube is still abnormal, the heater needs to be replaced.
3. When the multi-objects are bundled, the equipment cannot detect the packaged object, and the packaging causes damage to the packaging, which makes the packaging work impossible. This occurs because the heat shrink packaging machine is in the middle of the object during the bundle packaging. The gap affects the detection of the electric eye, and only needs to adjust the angle of the electric eye detection of the heat shrink packaging machine to an oblique angle to avoid the occurrence of the above phenomenon.
The above three faults are common faults in the production of heat shrink packaging machines. We hope that the solutions we provide will help you to use and produce better, so as to improve production efficiency, reduce packaging losses and improve the product market. Competitiveness.